2014년 1월 24일 금요일

Volcanic eruptions

Lava Flows

The root zone of volcanoes is found some 70 to 200 km (40 to 120 miles) below the surface of the Earth. There, in the Earth’s upper mantle, temperatures are high enough to melt rock and form magma. At these depths, magma is generally less dense than the solid rocks surrounding and overlying it, and so it rises toward the surface by the buoyant force of gravity. In some cases, as in the undersea zones where the tectonic plates of the Earth’s crust are separating, magma may move directly up to the surface through fissures that reach as deep as the mantle. In other cases, it collects in large underground reservoirs known as magma chambers before erupting to the surface. Molten rock that reaches the surface is called lava.

Most magma formed by partial melting of the mantle is basaltic in composition, but, as it ascends, it assimilates silica, sodium, and potassium from the surrounding host rocks. Volcanic rocks found where magma erupts to the surface are classified into four major types, or “clans”—basalt, andesite, dacite, and rhyolite.

Pahoehoe lava flow, Kilauea volcano, Hawaii, November 1985.
[Credit: J. D. Griggs, U. S. Geological Survey]If the vast, unseen undersea lava flows of the oceanic ridge system are considered, lava flows are the most common products of the Earth’s volcanoes. There are two major types of lava flow, referred to around the world by their Hawaiian names: pahoehoe, a more fluid flow with a smooth to ropy surface; and aa (or a’a), a more viscous flow whose surface is covered by thick, jumbled piles of loose, sharp blocks. Both types have the same chemical composition; the difference seems to be in the eruptive temperature and the speed of movement of the flow. As much as 99 percent of the island of Hawaii is composed of aa and pahoehoe flows. Indeed, Kilauea volcano has erupted continuously since 1983, its lava flows covering more than 100 square km (40 square miles) of land and adding more than 2 square km (0.8 square mile) to the island where the lava has poured into the ocean. In the Mediterranean region, Mount Etna has issued lava more than 150 times since its first recorded activity in 1500 bc.

Explosions
A cloud of ash and pumice rises into the air on July 22, 1980, following an explosive eruption of …
[Credit: Mike Doukas/U.S. Geological Survey]Massive volcanic explosions are caused by the rapid expansion of gases, which in turn can be triggered by the sudden depressurization of a shallow hydrothermal system or gas-charged magma body or by the rapid mixing of magma with groundwater. The ash, cinders, hot fragments, and bombs thrown out in these explosions are the major products observed in volcanic eruptions around the world. These solid products are classified by size. Volcanic dust is the finest, usually about the consistency of flour. Volcanic ash is also fine but more gritty, with particles up to the size of grains of rice. Cinders, sometimes called scoriae, are the next in size; these coarse fragments can range from 2 mm (0.08 inch) up to about 64 mm (2.5 inches). Fragments larger than 64 mm are called either blocks or bombs. Volcanic blocks are usually older rock broken by the explosive opening of a new vent. Large blocks ejected in such explosions have been hurled as far as 20 km (12 miles) from the vent. Volcanic bombs, in contrast, are generally incandescent and soft during their flight. Some bombs take on strange, twisted shapes as they spin through the air. Others have a cracked and separated crust that has cooled and hardened in flight; they are called “breadcrust bombs.”

A directed blast in which one side of a volcanic cone fails, as happened at Mount St. Helens in the United States in 1980, can cause destruction over several hundred square kilometres on the failed flank of the volcano. This is especially true if the blast cloud is heavily laden with fragmental debris and becomes dense and fluidized. It then takes on characteristics similar to a pyroclastic flow.

Ash falls
Buildings and vegetation at Clark Air Base, Philippines, are destroyed by a thick, wet layer of ash …
[Credit: Willie Scott/U.S. Geological Survey]Ash falls from continued explosive jetting of fine volcanic particles into high ash clouds generally do not cause any direct fatalities. However, where the ash accumulates more than a few centimetres, collapsing roofs and failure of crops are major secondary hazards. Crop failure can occur over large areas downwind from major ash eruptions, and widespread famine and disease may result, especially in poorly developed countries. In the long run, however, the decomposition of nutrient-rich volcanic fallout is responsible for some of the world’s best soils.

Hot springs and geysers

Hot springs and geysers also are manifestations of volcanic activity. They result from the interaction of groundwater with magma or with solidified but still-hot igneous rocks at shallow depths.
Geysers in Yellowstone National Park, northwestern Wyoming, U.S.
[Credit: Encyclopædia Britannica, Inc.]Yellowstone National Park in the United States is one of the most famous areas of hot springs and geysers in the world. The total heat flux from these thermal features is estimated to be 300 megawatts (300 million watts). The last great eruption at Yellowstone occurred about 630,000 years ago when some 1,000 cubic km (240 cubic miles) of rhyolitic pumice and ash were ejected in huge pyroclastic flows and resulted in the formation of a caldera—a large circular or oval depression caused by collapse of the surface following magma removal—approximately 45 by 75 km (28 by 47 miles) in size. Yellowstone Lake now occupies part of this giant caldera. Since that last great outburst, about 1,200 cubic km (288 cubic miles) of rhyolite lava flows and domes have erupted in numerous smaller events. The cooling roots of such past eruptions, or possibly the new intrusions of magma at shallow depth, are the heat sources for the Yellowstone hot springs and geysers.

Cross section of a geyser and hot spring
[Credit: Encyclopædia Britannica, Inc.]Geysers are hot springs that intermittently spout a column of hot water and steam into the air. This action is caused by the water in deep conduits beneath a geyser approaching or reaching the boiling point. At 300 metres (about 1,000 feet) below the surface, the boiling point of water increases to approximately 230 °C (450 °F) because of the increased pressure of the overlying water. As bubbles of steam or dissolved gas begin to form, rise, and expand, hot water spills from the geyser’s vent, lowering the pressure on the water column below. Water at depth then momentarily exceeds its boiling point and flashes into steam, forcing additional water from the vent. This chain reaction continues until the geyser exhausts its supply of boiling water.

After a geyser stops spouting, the conduits at depth refill with groundwater, and reheating begins again. In geysers such as Yellowstone’s Old Faithful, the spouting and recharge period is quite regular. This famous geyser has gushed to heights of 30 to 55 metres (100 to 180 feet) about every 90 minutes for more than 100 years. If Old Faithful’s eruption lasts only a minute or two, the next interval will be shorter than average, while a four-minute eruption will be followed by a longer interval. Other geysers have much more erratic recharge times.

Volcano



Mount St. Helens volcano, viewed from the south during its eruption on May 18, 1980.
[Credit: © Getty Images]volcano, vent in the crust of the Earth or another planet or satellite, from which issue eruptions of molten rock, hot rock fragments, and hot gases. A volcanic eruption is an awesome display of the Earth’s power. Yet while eruptions are spectacular to watch, they can cause disastrous loss of life and property, especially in densely populated regions of the world. Sometimes beginning with an accumulation of gas-rich magma (molten underground rock) in reservoirs near the surface of the Earth, they can be preceded by emissions of steam and gas from small vents in the ground. Swarms of small earthquakes, which may be caused by a rising plug of dense, viscous magma oscillating against a sheath of more-permeable magma, may also signal volcanic eruptions, especially explosive ones. In some cases, magma rises in conduits to the surface as a thin and fluid lava, either flowing out continuously or shooting straight up in glowing fountains or curtains. In other cases, entrapped gases tear the magma into shreds and hurl viscous clots of lava into the air. In more violent eruptions, the magma conduit is cored out by an explosive blast, and solid fragments are ejected in a great cloud of ash-laden gas that rises tens of thousands of metres into the air. One feared phenomenon accompanying some explosive eruptions is the nuée ardente, or pyroclastic flow, a fluidized mixture of hot gas and incandescent particles that sweeps down a volcano’s flanks, incinerating everything in its path. Great destruction also can result when ash collects on a high snowfield or glacier, melting large quantities of ice into a flood that can rush down a volcano’s slopes as an unstoppable mudflow. (See the table of the world’s major volcanoes by region.)

Mount Fuji, Japan.
[Credit: Earl and Nazima Kowall/Corbis]Strictly speaking, the term volcano means the vent from which magma and other substances erupt to the surface, but it can also refer to the landform created by the accumulation of solidified lava and volcanic debris near the vent. One can say, for example, that large lava flows erupt from Mauna Loa volcano in Hawaii, referring here to the vent; but one can also say that Mauna Loa is a gently sloping volcano of great size, the reference in this case being to the landform. Volcanic landforms have evolved over time as a result of repeated volcanic activity. Mauna Loa typifies a shield volcano, which is a huge, gently sloping landform built up of many eruptions of fluid lava. Mount Fuji in Japan is an entirely different formation. With its striking steep slopes built up of layers of ash and lava, Mount Fuji is a classic stratovolcano. Iceland provides fine examples of volcanic plateaus, while the seafloor around Iceland provides excellent examples of submarine volcanic structures.

Volcanic activity and the Earth’s tectonic plates
[Credit: Encyclopædia Britannica, Inc.]Volcanoes figure prominently in the mythology of many peoples who have learned to live with eruptions, but science was late in recognizing the important role of volcanism in the evolution of the Earth. As late as 1768, the first edition of Encyclopædia Britannica gave voice to a common misconception by defining volcanoes as “burning mountains, which probably are made up of sulphur and some other matter proper to ferment with it, and take fire.” Today geologists agree that volcanism is a profound process resulting from the thermal evolution of planetary bodies. Heat does not easily escape from large bodies such as the Earth by the processes of conduction or radiation. Instead, heat is transferred from the Earth’s interior largely by convection—that is, the partial melting of the Earth’s crust and mantle and the buoyant rise of magma to the surface. Volcanoes are the surface sign of this thermal process. Their roots reach deep inside the Earth, and their fruits are hurled high into the atmosphere.


Volcanoes are closely associated with plate tectonic activity. Most volcanoes, such as those of Japan and Iceland, occur on the margins of the enormous solid rocky plates that make up the Earth’s surface. Other volcanoes, such as those of the Hawaiian Islands, occur in the middle of a plate, providing important evidence as to the direction and rate of plate motion.

The study of volcanoes and their products is known as volcanology, but these phenomena are not the realm of any single scientific discipline. Rather, they are studied by many scientists from several specialties: geophysicists and geochemists, who probe the deep roots of volcanoes and monitor signs of future eruptions; geologists, who decipher prehistoric volcanic activity and infer the likely nature of future eruptions; biologists, who learn how plants and animals colonize recently erupted volcanic rocks; and meteorologists, who determine the effects of volcanic dust and gases on the atmosphere, weather, and climate.

Clearly the destructive potential of volcanoes is tremendous. But the risk to people living nearby can be reduced significantly by assessing volcanic hazards, monitoring volcanic activity and forecasting eruptions, and instituting procedures for evacuating populations. In addition, volcanism affects humankind in beneficial ways. Volcanism provides beautiful scenery, fertile soils, valuable mineral deposits, and geothermal energy. Over geologic time, volcanoes recycle the Earth’s hydrosphere and atmosphere.